Hitec D954SW High-Torque Steel Gear Servo

• Coreless metal brush motor
• Programmable PWM Digital Amplifier
• 32-Bit MCU with 12-Bit ADC circuitry

• End Point Adjustments
• Direction
• Fail Safe
• Dead Band
• Speed (slower)
• Soft Start Rate
• Overload Protection
• Data SaveLoad
• Program Reset
• 4096 resolution
• Nylon reinforced plastic upper and lower case with aluminum heat
• sink center case
• Dust resistant and splash proof
• Dual ball bearing supported output shaft
• 1M cycle long life potentiometer

• D954SW Servo
• 1.7 (44mm) long Double Arm
• 1.69 (43mm) 4-Point Horn
• 1.4 (36mm) diameter Round Horn
• 1.04 (26.5mm) Single Arm Horn
• 3mm Horn Screw, & Hex Socket Screw
• Four each Grommets, Eyelets and Mounting Screws

Voltage Range: 4.8 - 8.4V
Speed: 0.19 - 0.12 sec 60
Maximum Torque Range: 251 - 405 ozin (18.0 - 29.0 kgcm)
Dimensions: 1.57 x 0.78 x 1.46 (40.0 x 20.0 x 37.0mm)
Weight: 2.40 oz (68g)
Output Shaft: 25 tooth
Gear Material: MK 1st gear & 3 steel alloy gears
Circuit Type: 32bit programmable digital
Current Draw at Idle: 30 mA
No Load Operating Current Draw: 500 mA
Stall Current Draw: 5,200 mA
Connector Wire Gauge: 2080 AWG

*Programmable features require HITEC HPF-30 Servo Programmer.
HRCM4427, or the DPC-11 HRCP4429 Programming Interface, HRCP4429.