"2Pac" HD Dual Battery Share 50 AMP! - Deans Connectors

Heavy Duty Dual Battery System
2 PAC Battery Backer – Heavy Duty with Deans plugs 16 AWG Wire
Dual battery sharing system.

Draws evenly on both packs, or runs off single pack if you have a battery failure.
Great redundancy for your large scale aircraft.
Light weight, Reliable and can handle 50 Amps !
Low forward voltage drop (only 530mV @ 40 amps)
Auto Selects pack with highest voltage
Built in noise cancelling circuit >100db
Small size (smallest in market class)
16 AWG Heavy duty wires
Li-Po/Li-Ion/Ni-Mh/Ni-Cad Operation
Increased Voltage out compared to other devices
Increased Servo Speed!

Ratings

· Max Input Voltage 18V ( 5-C lipo)

· Max Load 25 Amps per input (50 Amps)

· 4 or 5 Cell Operation (Nicad and Ni-Mh)

· 2 Cell Li-Po / Li-Ion Packs must be used with Voltage Regulator on output side

Manufactured by 42Percents Products, USA.

In Summary

The 2Pac Battery Backer allows you to use two battery packs and two switches to provide Dual-Redundant security to your airborne system. With the 2Pac Batt Share, you can tolerate a single failure (open-circuit, short-circuit, low voltage) in either battery pack, or switch, or battery wiring, without losing radio control.

The 2PAC Battery Backer continually monitors both battery packs and switches for the one with the higher voltage, and routes that to your Rx and servos. You may combine different size packs. In practice, with two good packs, the 2PAC draws power equally from both packs, adding their individual capacities. I.e., if Battery #1 is a 6V/1350mAH pack, and Battery #2 is a 6V/2700mAH pack, you will have 4050mAH power supply onboard, with at least 1350mAH to fly on, in case of a failure. Though packs of similar or same capacity are more practical and recommended.


Use two battery packs and two switches to provide Dual-Redundant security to your airborne system